Loaded: loaded enabled vendor preset: disabled)Īctive: active (running) since Sat 01:40:25 EET 5s ago I am able to start the vncserver ~]# systemctl start ~]# systemctl status - Remote desktop service (VNC) I have followed all the steps described in How To Install and Configure VNC Remote Access for the GNOME Desktop on CentOS 7. When I reboot the server, it works nice, but after a while it start failing and when I connect there's no desktop and there's a pop-up windows appearing and disappearing. (Details - 1: Failed to get connection to session: Failed to connect to socket /tmp/dbus-Auq6圎VNZb: Connection refused) (Details - 1: Failed to get connection to session: Failed to connect to socket /tmp/dbus-Auq6圎VNZb: Connection refused)GConf warning: failure listing pairs in `/apps/nautilus/desktop-metadata': Failed to contact configuration server some possible causes are that you need to enable TCP/IP networking for ORBit, or you have stale NFS locks due to a system crash. I'm having this error from the log file of a Tiger VNC server (version tigervnc-server-1.1.0-5.el6_4.1.x86_64):įailed to contact configuration server some possible causes are that you need to enable TCP/IP networking for ORBit, or you have stale NFS locks due to a system crash. However, you will see that they do not state: 5801:5803, which I have to add in order to get the VNCViewer working. With your correct eth in ifconfig, add the following lines to your iptables: A FORWARD -j REJECT -reject-with icmp-host-prohibited A INPUT -j REJECT -reject-with icmp-host-prohibited A INPUT -m state -state NEW -m tcp -p tcp -dport 22 -j ACCEPT A INPUT -m state -state ESTABLISHED,RELATED -j ACCEPT # Manual customization of this file is not recommended. # Firewall configuration written by system-config-firewall
0 Comments
Leave a Reply. |